Is this the card? Unfortunately, I couldn’t get very far to installing the utility software as it doesn’t detect the card, even in Windows and DOS with the packet driver successfully installed. Could be just a duff card, it happens. I’ve pretty much given up on the Ether Return to General Old Hardware.
|Date Added:||22 October 2017|
|File Size:||41.92 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Or maybe, recove all other Cards you dont need for Dos and try Setup again. Is this the card? If so try half duplex or whatever the opposing current setting is. I ended up replacing it with a PCI card and permanently installing it into the where it had no problem and is actually a good card, also ran the other one in a for years before putting a PCI one in only because I had no spare ISA Ethernet cards for a non-PCI system I was messing with.
Have the SB16 liksys Yamaha sound card installed alongside. Still can’t connect to the network. Setting it manually to what I know is correct gives me a warning about changing resources but everything works suddenly I’m not familiar with that particular card but I’m guessing the driver dther16 has a setup program where you assign IRQ plus less important stuff like frame type, etc or try another PCI slot and hope plug and play assigns it another one.
Now the next problem is trying to get an IP address, which it won’t do. I Can’t help wondering if it could be a clock dependency of some sort – i. Still couldn’t get an IP address from the router and couldn’t do a loopback that way.
Another thing you could try is dropping to dos or even test it in a dos system using a suitable packet driver and see if you can get it to connect using the mTCP suite of apps. Though, I do know that it detects it under Windows just fine.
And unfortunately, I don’t have a hub or a switch. Unfortunately, I couldn’t get very far to installing the utility software as it doesn’t detect the card, even in Windows and DOS with the packet driver successfully installed.
Strange, given it is an NE clone. Well unfortunately, I can’t seem to find the option to turn down the BUS clock to see if that would make any difference at all. You do not have the required permissions to view the files attached to this post. I’m beginning to think that it could be some sort of resource conflict, even though Windows doesn’t suspect it and that the SB16 is not even using it.
Could be just a duff card, it happens. Unrelated but it’s probably a good time lin,sys mention limksys was a Winsock update for Windows 95 as well- http: If I have the time and motivation to do so, I’ll test it in another machine.
Linksys Ether16 LAN Card
There is no material that is knowingly illegal here. Looking for vintage computers and parts. Caluser Yes, that’s the exact card that I’m using. That’s not a good sign then that the card is not detected. This site hosts no abandonware. What version of Windows 95?
My 3C exhibits similar behavior in one of my ‘s if I ramp up the BUS Clock and the configuration tool will either not detect it or permanently damage the card. Also do you have another card you can use?
Linksys LNE2000 – Ether16 Combo LAN Card
Just won’t freaking get an IP address from the router. PM me if you have some to give erher16. Did a little further testing. I’ve installed it into the system and it seems to be working fine. Users browsing this forum: Check you have the correct resources set Windows always gets my network cards IRQ wrong on a fresh install but if you believed windows everything is fine. I’ve pretty much given up on the Ether